Glyco-San Aircraft Potable Water Tank Cleaner, Descaler & Disinfectant, 1 Gallon

Directions for Use:

It is a violation of Federal law to use this product in a manner inconsistent with its labeling. Use Glyco-San® to disinfect on-board potable water storage tanks and components associated with these tanks such as pipes, plumbing fixtures, aircraft water trucks and carts, and hoses. Glyco-San® is an effective disinfectant against Staphylococcus aureus (ATCC 6538), Salmonella enterica (ATCC 10708) and Escherichia coli (ATCC 11229).

Application Instructions:

Prior to disinfection, pre-clean water storage tanks and associated components with Glyco-San® by preparing a use-solution consisting of 1 part Glyco-San® to 3 parts of water (1:4). Prepare the Glyco-San® cleaning solution by either pumping the appropriate amount of water into the water storage tank or system followed by Glyco-San® addition, or by making up the Glyco-San® cleaning solution in a tank, drum or water cart and then pumping the Glyco-San® cleaning solution into the potable water tank. Pre-clean for a minimum of 30 minutes and, when necessary, up to 4 hours. After the pre-cleaning period is completed, thoroughly rinse the storage tank and associated components with potable water.

To disinfect, prepare a use-solution of 1 part of Glyco-San® to 7 parts of water (1:8) by either pumping the appropriate amount of water into the potable water tank followed by Glyco-San® addition, or by making up the Glyco-San® disinfectant solution in a tank, drum or water cart and then pumping the disinfectant use-solution into the potable water tank. After the disinfectant use-solution has filled the potable water tank, flush through the potable water system for 1 minute by opening all taps, including the coffee maker and vacuum toilets (where appropriate). This will allow the disinfectant use-solution to come in contact with all surfaces that contact potable water. Flush the lavatory 1-2 times. Allow the use-solution to soak in-place for at least 30 minutes and then flush to a sanitary sewer drain. Once drained, flush the potable water system with water to remove any traces of the disinfectant use-solution. In order to determine whether the system is completely flushed, half fill a small jar with the rinse water, cap and shake. If the water in the jar DOES NOT FOAM, the system has been thoroughly flushed. Glyco-San® can also be used to disinfect the aircraft coffee maker during shop cleaning. If heavily soiled, pre-clean the coffee maker with a suitable detergent or a 1:4 dilution of Glyco-San®. To disinfect, prepare a use-solution 1 part of Glyco-San® to 7 parts of water (1:8). Make a full pot of hot water using the Glyco-San® use -solution and allow to soak in-place for at least 30 minutes, Continue to make pots of hot water using only tap water until hot water DOES NOT FOAM when shaken in a small, capped jar. Absence of foam indicates that the disinfectant solution has been flushed from the coffee maker.